Epson Et2400 Reset Page

Release both buttons. The lights will flash for about a minute and then turn off. Ready for Setup:

Once the lights are off, the network memory is cleared. To enter setup mode again, hold the button for 5 seconds until the lights flash. 2. Factory Reset (General System Reset)

Press and hold the Network button (left button with a wireless symbol) and the Power button simultaneously for about four to five seconds. epson et2400 reset

Unplug the printer from the wall, wait 5-10 minutes , and plug it directly into a wall outlet (avoid power strips).

The printer has a built-in waste ink pad. Epson sets a counter that stops the printer after ~10,000–15,000 pages. This is a , not available in normal menus. Release both buttons

Resetting your printer is a troubleshooting step, not a regular maintenance task. You should perform a reset if you experience:

This procedure resolves Wi-Fi connectivity issues, enabling the printer to connect to a new network or pair with a new device. Turn off the printer. To enter setup mode again, hold the button

Check the boxes next to Black, Cyan, Magenta, or Yellow, and confirm the reset.

the Power button for 15 seconds while the machine is unplugged.

If your ET-2400 refuses to connect to your local network, resetting the internal network card back to its factory default state will allow you to run a clean setup. your printer.