The crane has reached its maximum rated lifting capacity.
If possible, safely lower or support any suspended load.
: The screen will flash two sets of numbers, like 21.12 .
Once the area was clean and dry, Elias climbed back into the operator’s seat. He took a breath and pressed the power button again. palfingercranemanualerrorcodes
Inspect the proximity switches and angle sensors for physical alignment or damage.
Simultaneously press and hold the Power and OOLP (Outrigger Limit Position) buttons.
Disclaimer: This guide is for informational purposes. Always consult a qualified technician for repairs. If you'd like, let me know: (e.g., 21.12, 32.xx)? What is your crane model (e.g., PK 332E, PK 8501)? Palfinger Crane Error Codes Guide | PDF - Scribd The crane has reached its maximum rated lifting capacity
Check wiring/plugs. Swap U230 and U231 plugs to test for a faulty sensor. Transducer Signal High Signal above 19.7 mA; potential short circuit.
This article helps you understand to quickly fix common crane issues.
While there are numerous error codes specific to Palfinger cranes, here are some common ones: Once the area was clean and dry, Elias
Marked with two stars (**), these indicate a system fault, such as a sensor failure or wiring short. These often require a manual reset or repair.
These error codes are the primary language used by the (the crane's electronic control system) and the RC (Remote Control) units to communicate specific mechanical, hydraulic, or electronic faults to operators and service technicians. 🏗️ System Overview