Ts1162 Installation Manual Exclusive _hot_ 95%

Firmware update procedure

The TS1162 typically features switching capabilities. This means it can switch two separate circuits simultaneously, or one circuit while keeping one neutral pass-through.

Fasten the assembly utilizing the four pre-molded mounting corner points. Hand-tighten the fasteners until the back rubber gasket compresses flush against the surface wall. Do not over-torque using mechanical impact drivers. Wiring Topology & Terminal Assignments Go to product viewer dialog for this item. ts1162 installation manual exclusive

Technical specifications (assumed typical)

Choose a flat, dry, and secure location, preferably at a height comfortable for maintenance and away from extreme heat or direct sunlight. Hand-tighten the fasteners until the back rubber gasket

: If you require rear cable entry, cut a hole in the mounting surface. Use suitable screws to mount the base assembly, ensuring the tamper lever will be fully depressed once mounted to the wall. Reassemble

Access the tape library management GUI, navigate to the target slot frame, and place the slot into "Maintenance Mode." navigate to the target slot frame

: Includes a dedicated input for an egress button or RTE control.

The TS1162 uses a mechanical dial with "Trippers" (on/off levers).